Start-Up - GOK SmartBox 1 Instrucciones Para El Montaje Y El Funcionamiento

The functions and operating safety of the device are guaranteed only under the
climatic conditions that are specified in TECHNICAL DATA. If the device is transported from a
cold to a warm environment, condensation may cause the device to malfunction or may even
destroy the device. Because of this, you must ensure that the device has acclimatised to the
ambient temperature before using it.
If you have any doubts that the device can be operated safely, do not operate it.
Your safety may be adversely affected by the device, if for example:
• it is obviously damaged
• it no longer works as specified
• it has been stored in unsuitable conditions for some time.
If in doubt, send the device to the manufacturer for repair or maintenance
Observe the safety precautions and the assembly and operating instructions of
connected devices.
Connection of the relay contacts at the indicator SmartBox
The indicator SmartBox
connection of external control circuits or for activating external alarm or signal devices.
In case of failure of the unit and if the fill level (or optionally the temperature) is above / below
the selected limit, the contacts of relay terminals 6 + 7 and 9 + 10 are closed. Contacts of
relay terminals 5 + 6 and 8 + 9 are open - see the legend on the PCB in the unit.
Switching voltage
Switching current
Excess voltage!
Damage to components and device defect.
No 230 V AC connections may be made to terminals 3 + 4 or probe input terminals 1 + 2!
Activating power supply:
Keep away from the area of the 230 V terminal!
Connection
Relay 1
Relay 2
Connection of interface to SmartBox
The measured values can be transmitted to the SmartBox
integrated interface "SERIAL LINK OUTPUT" (terminals 3 + 4).

START-UP

Operation elements and display
The device is adjusted once when it is put into operation. After start-up the device operates in
display mode with the top closed.
The display is a two-line LCD display with 2 x 16 characters.
The display has blue background lighting for best readability in all lighting conditions.
22 / 112
®
2 has two relay contact pairs (SmartBox
max. 250 V AC
max. 3,5 A
normally open (NO)
terminals 5 + 6
terminals 8 + 9
®
SmartBox 1 / SmartBox
normally closed (NC)
terminals 6 + 7
terminals 9 + 10
® ®
4, SmartBox 5
®
®
2 / SmartBox
®
2 und SmartBox
®
3  one relay) for the
only SmartBox
2
2 + 3
®
4, SmartBox 5 set via the
Artikel-Nr. 28 100 51 h
®
3
®
3
®