Installing The Saddle Drain Clamp; Mounting Ro Unit Under Sink - PUR PQC3RO Manual Del

Sistemas de filtrado por ósmosis inversa de conexión rápida debajo del fregadero
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation Instructions (continued):
Installing the Saddle Drain Clamp (See Figure 9 and 10):
1. Attach the Saddle Drain Clamp to the vertical section of the drain pipe,
about 2 inches above the drain trap.
2. Using the fittings hole of the Saddle Drain Clamp as a guide, drill a 1/4"
hole through one side of the drainpipe.
CAUTION: Do not penetrate through the opposite side of the pipe.
3. Remove the Drain Clamp from the drainpipe and enlarge the hole with a
3/8" drill bit. Use a file to remove rough edges from the drilled hole.
4. Squarely cut the end of the 3/8" Black Tube. Insert the Tube through the
Saddle Drain Clamp quick-connect fitting about 1" past the inside wall of
the Saddle Drain Clamp.
5. Make sure the Black Rubber Gasket is adhered to the inside wall of the
Saddle Drain Clamp and place the Saddle Drain Clamp assembly over the
drainpipe. Insert 3/8" black tube into the drilled hole. Tighten the Clamp.
CAUTION: Do not overtighten the screws, it may crack the Clamp.
CAUTION: The 3/8" Black Drain Tube must be as SHORT and
STRAIGHT as possible to the Saddle Drain Clamp, making a
downward slope from the faucet to the Saddle Drain Clamp to
allow for proper drainage. This is a gravity fed line and if there is
any bend or dip in the Tubing, the rinse water will not flow into the
drain properly. Water may back up and come out the Air Gap Hole
in the Faucet.
Mounting the RO Unit Under the Sink:
1. Position the RO unit on the back or right walls under the sink. Make sure to allow ample space for the installation and
plumbing connections. To change the filter cartridges, 2" of clearance is required underneath the filter housings.
2. Install mounting screws at least 15-3/4" from cabinet floor. Leave 1/4" space between the head of the screw and the wall
to slip bracket onto the screws. Then tighten the screws to secure the system.
System Dimensions
PQC3RO
2" Clearance
9
10"
7-7/8"
15-1/4"
Figure 9
Figure 10
Drain Clamp
Front Plate
14"
11-1/2"
15-3/4"
Never
Mount
Here
Black Rubber
Gasket
3/8" Black
Drain
Drain Tubing
Pipe
PQC4RO
PQC5RO
15-1/4"
2" Clearance
Mount
Drain
Valve
Here
Drain
Clamp
Back
Plate

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pqc4roPqc5ro

Tabla de contenido