Fan Assembly. Pgs - Craftmade Ellington BTY52ABZC5 Manual Del Usuario

5. Fan Assembly.
If you wish to extend the hanging length of your
fan, you must remove the hanging ball from the 6in.
downrod provided to use with an extended
downrod (sold separately). [If you wish to use the 6in.
downrod, please proceed to instructions following the
dotted line below.]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove stop
pin. Slide hanging ball off the original downrod, A,
and slide it down the longer downrod, B (the top of
the downrod should be noted as having a set screw
hole; use this hole when setting the set screw).
Insert stop pin into top of extended downrod and
raise hanging ball. Be sure stop pin aligns with slots
on the inside of the hanging ball. Tighten set screw
securely.
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
Locate canopy cover in hardware pack. Loosen
yoke set screws and nuts in motor housing yoke
and remove pin and clip from motor housing yoke.
Slide downrod through canopy, canopy cover and
yoke cover. [Note: Canopy cover must be turned
with shiny side toward the motor housing.]
Thread safety cable and electrical wires through
downrod and pull extra wire slack from the upper
end of the downrod.
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes
in yoke--make sure wires do not get twisted. Re-insert
pin and clip that were previously removed. Tighten
yoke set screws and nuts securely. Lower yoke
cover to motor housing.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not
meant to cover all possible conditions and
situations that may occur. It must be understood
that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
A
electrical wiring
yoke cover
clip
page 4
set screw hole
stop pin
hanging ball
B
safety cable
downrod
canopy
canopy cover
yoke set screw
pin
motor
housing