Blade Assembly; Light Kit Assembly (Optional). Pgs - Craftmade Ellington BTY52ABZC5 Manual Del Usuario

8. Blade Assembly.

Time Saver: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers in
hardware packs. Hold blade arm up to blade and
align holes. Insert 3 blade attachment screws
(along with washers) with fingers first and then
tighten screws securely with a Phillips screwdriver.
Repeat procedure for the remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (save blade arm screws and lock
washers to secure blade arms). Align blade arm
holes with motor screw holes and attach blade
arm with lock washers and blade arm screws.
Before securing screws permanently, repeat this
procedure with remaining blade arms. Securely
tighten all screws.
Note: Tighten blade arm screws twice a year.
9. Light Kit Assembly (Optional).
Remove 3 screws from outer edge of fitter
plate (save screws for later use).
Remove 1 screw from motor plate (on
underside of motor) and loosen the other 2
screws. Align slotted holes in fitter plate with
loosened screws in motor plate, allowing the
male plug from the motor housing to come
through hole in middle of fitter plate. Twist
fitter plate to lock. Re-insert screws that were
previously removed and securely tighten all 3
screws with a Phillips screwdriver.
If you wish to use fan WITHOUT the light kit,
remove hex nut and lock washer from threaded
rod at top of light kit fitter and then remove the
switch housing cap. Locate plug in hardware pack
and place in hole in center of switch housing cap.
Align holes in switch housing cap with holes in
fitter plate. Attach switch housing cap to fitter
plate with 3 screws that were previously removed.
Securely tighten all 3 screws with Phillips
screwdriver.
["Light Kit Assembly" continued on next page.]
plastic
motor
lock
blade arm
switch housing cap
(at top of light kit fitter)
motor housing
light
kit
fitter
motor housing
switch
housing
cap
page 7
motor housing
blade attachment
screws and washers
blade
lock washers
blade arm screws
fitter plate
male plug
fitter plate
fitter plate
center cap