Troy-Bilt 700 Serie Manual Del Operador página 8

Overhead Chute Rotation Control
Chute
Assembly
Figure 6
1. Remove wing nut (a) and hex screw (b) from chute control
head and clevis pin (c) and bow-tie cotter pin (d) from chute
support bracket. Position chute assembly (forward-facing)
over chute base and chute support bracket (Figure 7).
c
b
a
Chute
Assembly
Chute Base
Figure 7
2. Secure chute control head to chute support bracket with
clevis pin (c) and bow-tie cotter pin (d) removed in Step 1
(Figure 8).
c
Figure 8
ASSEMBLY
Chute Control Rod
Chute Control Head
Chute Support
Bracket
d
d
3. Finish securing chute control head to chute support bracket
with wing nut (a) and hex screw (b) removed in Step 1
(Figure 9).
4. Insert chute control rod into the support bracket on rear of
the dash panel (Figure 10).
5. Remove hairpin clip (e) from rear of chute control head
(Figure 11).
6. Insert chute control rod (b) into rear of chute control head
(Figure 11) and secure with hairpin clip (e) removed in Step 5.
Continue to Set-Up (page 13).
8
b
a
Figure 9
Figure 10
e
Figure 11
STOP
b