Littium Berlin Manual Del Usuario Y Garantía página 51

Error Definition Table
Error
2
3
4
5
6
7
8
A/10
D/13
F/15
Definition
The controller verifies the protection over the electric current. Make sure that the power cable and
signal connectors are connected properly. If the error still shows after reconnecting the connec-
tors, it means there is something wrong with the controller or the engine.
The controller is not making the engine work as it should. Make sure that the power cable and
signal connectors are connected properly. There might not be enough power to drive the system.
If the error still shows after reconnecting the connectors, it means there is something wrong with
the controller or the engine.
The battery voltage is too low.
After tuning on the system, check whether the brakes are working properly or not. If the brakes'
signal is less than 0.75V for a long period of time, it means there is something wrong with the
brakes.
Check whether the engine sensor switching signal is working properly or not. Then, check whether
the signal of the engine's connector cable is disconnected or not. If the error still shows after
reconnecting the connectors, it means the engine sensor is broken.
After turning on the system, check if the throttle is out of control or if the signal is less than 0.75V.
It could also be due to the user functioning the throttle before the system is working. This error will
be solved after restarting the throttle.
The controller is broken.
The screen and the controller are undergoing communication problems. The green wire may be
disconnected, or a poor connection may be hampering proper communication.
The controller programme or the 5V is not working properly. Check whether the brakes' signal cuts
off with 5V or not.
The screen and the controller are undergoing communication problems. The green wire may be
disconnected, or a poor connection may be hampering proper communication.
47