Regulations; Assistance; Danger Zones - Simu GM600 Manual De Instalación

GM600
Take care when using the manual back release device
as an open door can suddenly fall off if the springs are
weak, broken, or incorrectly balanced.
ATTENTION
Install any fixed control device at a height of less than
1.5 m and within sight of the door, but away from moving
parts.
After installation, ensure that:
- the mechanism is correctly adjusted
- the manual back release device is operating correctly
- the motorisation changes direction when the door
encounters an object 50 mm high on the ground.
For operation in automatic mode or remote control,
photoelectric cells must be installed.
For operation in automatic mode, or if the garage door
faces a public road, an orange light type signalling device
may be required to comply with the regulations in the
country in which the motorisation is installed.
> Clothing precautions
Take off any jewellery (bracelet, chain, etc.) during
installation.
For manoeuvring, drilling and welding operations, wear
appropriate protection (special glasses, gloves, ear
protection, etc.).

1.6 Regulations

SIMU declares that this product
GM600
complies with the essential requirements of applicable
European directives.
The full text of the CE declaration of conformity is
available at the following website www.simu.com.

1.7 Assistance

You may encounter difficulties or have questions when
installing your motorisation.
Do not hesitate to contact us; our specialists are on hand
to answer all your questions. Internet: www.simu.com

1.8 Danger zones

Risk prevention - motorisation of sectional/up and
over garage door for residential usage
Zone 4
Zone 5
Zone 3
Zone 4
3
WARNING
WARNING
Zone 2
Zone 1
Zone 3
Zone 1
Zone 4
Risk zones: measures to be taken to eliminate risks
RISK SOLUTION
ZONE 1 Obstacle detection built into
the motorisation. It must be
Risk of crushing
imperatively checked that the
between the ground
obstacle detection complies with
and the lower edge
annex A of the standard EN 12
of the door during
453.
closing
For operation with automatic
closing, install photoelectric cells
(see installation manual)
ZONE 2* Obstacle detection built into
the motorisation. It must be
Risk of crushing
imperatively checked that the
between the lintel and
obstacle detection complies with
the upper edge of the
annex A of the standard EN 12
door during closing
453.
ZONE 3* Eliminate all sticking points and
all sharp edges from the surface
Risk of cutting or
of the door
trapping between the
door panels in gaps Eliminate any gap ≥ 8 mm or
of between 8mm and ≤ 25 mm
25mm
ZONE 4* Eliminate all sharp edges on the
guide rails
Risk of trapping
between the roller rails Eliminate any gap ≥ 8 mm
and bearings between the rails and the
bearings
ZONE 5* Obstacle detection built into
the motorisation. It must be
Risk of crushing
imperatively checked that the
between the
obstacle detection complies with
secondary edges and
annex A of the standard EN 12
adjoining fixed parts
453.
* For zones 2, 3, 4 and 5, no protection is required if the
door has continuous control or if the danger zone is more
than 2.5 m above the ground or any other permanent
access level.
Zone 2
Zone 5
Copyright © 2015 Simu SAS. All rights reserved