Urmet 1099/811 Guía Rápida página 10

EN
1 Introduction
Thank you for purchasing a 1099/811, access control device with face recognition, temperature
measurement and face-covering detection. Please read this manual carefully to use the device
correctly and safely, in particular the section on safe use.
Before using this product, please read the product manual carefully and keep it for future reference.
Extracting, copying, translating or modifying this manual in any way in whole or in part without
written permission is forbidden. No representations or warranties, either express or implied, are
released unless otherwise agreed.
Warranty and liability
URMET guarantees that the product is free from defects in materials and workmanship. This warranty
does not apply to damage caused by accident, negligence, misuse, tampering, contamination or
improper storage.
Precautions
Make sure that the device is intact after removing it from the package.
This quick start guide is only used to guide the installation of the device. Precautionary measures
are divided into hazards and warnings:
Hazards: Failure to observe any warning may result in serious injury or death.
Warnings: Failure to observe any of the precautions may result in injury or damage to equipment.
Hazards
All electronic operations must comply strictly with electrical safety, fire regulations and other
regulations in force in your region/country.
Use the power unit included.
Do not connect more than one device to the same power adapter as adapter overload may cause over-
heat or fire hazard.
Make sure the power supply has been disconnected before wiring, installing or disassembling the
device.
The device must be fixed securely when the product is installed on a wall or ceiling.
Check that the working temperature is within the indicated range and that the environment is
not excessively damp.
In case of smoke, odour or noise comes from the device, turn off the power immediately and
disconnect the power, then contact a service centre.
Make sure that the rating plate data corresponds to the power specifications before connecting
the device to the mains.
Do not swallow the battery; danger of chemical burns. This product contains a button cell battery.
If the button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can
lead to death.
Keep new and used batteries away from children.
If the battery has been swallowed, consult a doctor immediately.
If the product does not work properly, contact your nearest dealer or service centre.
Never attempt to dismantle or modify the device on your own. (We will not accept any liability
for problems caused by unauthorised repairs or maintenance)
Warnings
Do not drop the device or subject it to physical shocks and do not expose it to high levels of
electromagnetic radiation. Avoid installing the equipment on surfaces or places with vibration or
shock (may cause damage to the equipment).
Make sure the equipment is properly earthed to avoid interference and damage to video and
audio signals.
To use and operate the device optimally, configure it via a computer.
Do not place the device in extremely hot environments (refer to the specifications of the device
DS1099-066C 10