Urmet 1099/811 Guía Rápida página 14

EN
Device configuration
By default the device operates access control based on temperature measurement only.
You can change the default operation mode and other parameters from the device web page.
To access the web page of the device, use a network wire to connect the device to the LAN and
power it. The device will receive an IP address assigned automatically by the DHCP service of
the network.
The following steps are needed for configuration:
1. Start "EasyTool" on the PC by selecting
gateway and MAC address of each IP device active on the LAN will be automatically
displayed, as shown in the figure below.
3. After having detected the IP device, right-click and select "Open in IE" to open a Web page
on IE.
See the applicable section in the complete manual if the installation of an ActiveX
component is required (see paragraph below).
On the login screen on the browser, select the user name (default): "admin"), password
(default:""), Stream Type (Main/Sub Stream) and Language.
Suggested parameters
The suggested parameters are displayed below. To set these parameters click on 【Screen】
(【Display】) → (【Image Control】) in order to access to the following window.
DS1099-066C
: the IP address, subnet mask,
14