Disinfecting Unit - Aircare Space Saver Serie Configurar La Guía Y El Manual Del Propietario

5. Rinse the base thoroughly with fresh water to remove
scale and cleaning solution before disinfection.
6. Prepare unit for use by filling the base with cool,
clean water.
CAUTION DO NOT OVERFILL, AS LEAKING MAY OCCUR.
7. Install a new wick into the wick retainer. See
"Wick Replacement" on page 9.
8. Position the wick retainer in the base as de-
scribed on page 6, step 12.
9. Replace the Styrofoam float and float rod and
secure by twisting the retainer around the float
rod.
10. Place the chassis back onto the base ensuring
the float rod meets the small metal switch. (See
page 7.)
NOTE Ensure all assembly directions are followed carefully.

Disinfecting Unit

Disinfect the humidifier at the end of the season, (or
more often if needed).
1. Clean as described above.
2. Fill reservoir half full of water and add 1 teaspoon
of household bleach. Use same bleach and water
solution to clean reservoir in base. Let sit for 20
minutes.
3. Rinse base thoroughly until no smell of bleach
remains.
4. Wipe down exterior with soft cloth dampened
with clean water, then dry unit with soft, clean
cloth.
5. If you plan to continue using the humidifier,
refill and install a new wick as described in this
manual.
6. If storing the humidifier for the season, place it in
the original carton, if available. Do not store in at-
tic or other high temperature location, as damage
will occur.
FOR HELP, CALL 1.800.547.3888 OR VISIT AIRCAREPRODUCTS.COM
Tips for Humidity
• To start, set the humidity
level between 45-50%.
Adjust to desired level
after getting a baseline
reading.
• It may take up to 48
hours of operation to see
overall humidity levels
change.
• CDC tests show that
humidity levels of 43%
greatly reduce the ability
of the flu virus to spread.
• We recommend using
high speeds during the
day to spread humidified
air rapidly, and using low
speed at night.
10
Setting