Publicidad
Idiomas disponibles
Idiomas disponibles
2444MP3 DE,GB,FR &HR
INTRO (44) button
Enable:
Press once to introduce each track for 10 seconds and
Display (1).
Disable:
Press again back to normal playback.
Programming CD
The CD player enables program 64 tracks in sequence of your choice.
1. Press PROGRAM (43) button at stop mode, MEMORY and 00 P - 01 indicate on the Display
(1).
2. Press
SKIP - (14, 38) and
to select the desired track to be programmed.
3. Press PROGRAM (43) button to entry memory.
4. Continuous program, repeat steps 2 and 3 until memory is full.
5. Press
PLAY / PAUSE (9, 29) button on program mode to play the programmed tracks.
Note: Program will be erasing automatically from first track when you entry over 64 tracks.
Press PROGRAM (43) button repeatedly to check programmed tracks.
Clear the programmed tracks
•
Press
STOP (13, 28) button once in program mode.
•
Open the CD Door by pressing CD Door OPEN / CLOSE (5) button.
Note on CD-R/RW discs
•
Because of non-standardized format definition / production of CD-R/RW, playback quality &
performance are not guaranteed.
•
It is not responsible for the playability of CD-R/RW in any case due to recording conditions such as
PC performance, writing software, media ability and etc.
•
Do not attach a seal or label to either side (the record able side or the labeled side) of a CD-R/RW
disc. It may cause malfunction.
•
Do not load an un-recorded CD-R/RW disc. It will take over 30 seconds to read the disc. The disc
may be damaged if you try to open the disc compartment while reading the disc.
MP3 PLAYER OPERATION
1. Press POWER (4, 37) to turn the unit on. Press FUNC (36) repeatedly or
to select CD mode.
2. Press CD DOOR OPEN/CLOSE (5) button to open the CD door. Insert the disc with unlabelled
side facing to the unit. Press the center of the CD disc onto the black holder fitted with 3 retaining
bearing until locked.
3. Press CD DOOR OPEN/CLOSE (5) button to close door. The number of tracks and total playing
time of the CD will appear on the Display (1).
Note: If no disc or damaged disc was loaded, NO DISC will show on the Display (1).
PLAY / PAUSE (9, 29) button
PLAY:
Press once to start immediately.
PAUSE:
Press once during playback to suspend and the elapse time blinking on the Display (1).
RESUME: Press once during pause, continuous playback and the elapse time stop blinking on the
Display (1).
024.
9/7/05
3:29 PM
Page 024
SKIP + (12, 38) button or press numerical buttons "0-9" (32)
INTRO
indicates on the
PLAY/PAUSE (9, 29)
Publicidad
