Trouble Shooting Faq - Taurus PROFESSIONAL RONER CLIP Manual De Instrucciones

mains disturbance it may lose performance
and maybe it is needed to be unplugged to
recover the normal operation.
FOR EU PRODUCT VERSIONS AND/OR IN
CASE THAT IT IS REQUESTED IN YOUR
COUNTRY:
ECOLOGY AND RECYCLABILITY OF THE
PRODUCT
- The materials of which the packaging of this
appliance consists are included in a collection,
classification and recycling system. Should you
wish to dispose of them, use the appropriate
public recycling bins for each type of material.
- The product does not contain concentrations of
substances that could be considered harmful to
the environment.
This symbol means that in case you wish
to dispose of the product once its working
life has ended; take it to an authorised
waste agent for the selective collection of
Waste from Electric and Electronic
Equipment (WEEE).
This appliance complies with Directive 2014/35/
EU on Low Voltage, Directive 2014/30/EU on
Electromagnetic Compatibility, Directive 2011/65/
EU on the restrictions of the use of certain

TROUBLE SHOOTING FAQ

NOISE
GRINDING NOISE
SLURPING NOISE
GURGLING + WHOOSH
NOISE
hazardous substances in electrical and electro-
nic equipment and Directive 2009/125/EC on
the ecodesign requirements for energy-related
products.
STATEMENT OF COMPLIANCE
I hereby declare under our responsibility that the
TAURUS product/s described in this RONER
CLIP manual comply with the Regulations EN
60335-1, EN 60335-2-15, EN 62333, EN 55014-
1, EN 55014-2, EN 61000-3-2, EN 61000-3-3,
EN 62321 and EN 50564 in accordance with the
directives 2014/35/EU, 2014/30/EU, 2011/65/EU
y 2009/125/EC.
Signed:
15/12/2016
A. Martí
Product Engineering
Under the normal operation the system will hum due to the motor,
impeller and cooling fan in operation.
The stainless steel skirt is loose. Push the stainless skirt up into
the guide groove and turn to the right until you hear a click. With
the skirt secure, the noise will go away.
There also might be the chance the stirring shaft was inadvertently
bent. In this case, unscrew the bottom pump disk and gently push
the impeller until it is centered.
Your pump has formed a water vortex like when you are empting
out a bathroom sink or tub. Add more water or gently disturb water
with a spoon. There is no sure way to eliminate a vortex from for-
ming due to the pump rotation but usually will go away on its own.
The pump is sucking air add more water. You should also see
small bubbles in your tank.