Operating Your Remote Control - HAMPTON BAY Tropics Manual Del Propietário

Setting the Code
This unit has 16 different code combinations. To
set the code, perform the following steps:
A. Setting the code on the transmitter:
a. Remove the battery cover. Press firmly
below arrow and slide battery cover off.
b. Slide code switches to your choice of up
or down position. (Factory setting is all up).
B. Setting the code on the receiver.
a. Slide code switches to the same position
as set on your transmitter.
b. Replace battery cover on transmitter.
CAUTION:
Ceiling angle shall not exceed 15 degrees.
Remote Control Model: UC7067RC
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, REMEMBER TO DISCONNECT
POWER. DO NOT USE WITH SOLID STATE
FANS. THE ELECTRICAL WIRE MUST MEET ALL
LOCAL AND NATIONAL ELECTRICAL
REQUIREMENTS. ELECTRICAL SOURCE AND
FANS MUST BE 115/120 VOLT, 60 HZ . MAXIMUM
FAN MOTOR AMPS: 1.0. MAXIMUM LIGHT WATTS:
300 INCANDESCENT ONLY.

10. Operating Your Remote Control

Installing Receiver
A. Wire Connection:
Fan Green Wire ............................................................... Bare Supply Wire
Black Receiver Wire (AC IN L) ..................................... Black Supply Wire
White Receiver Wire (AC IN N) ..................................... White Supply Wire
White Receiver Wire (TO MOTOR N) ........................... White Fan Wire
Black Receiver Wire (TO MOTOR L) ............................ Black Fan Wire
Blue Receiver Wire (FOR LIGHT) ................................. Blue Light Wire
NOTE: If other fan wires are a different color, have this unit installed by a licensed electrician.
B. Lay the black antenna wire on top of the receiver, and slide the receiver into the mounting
bracket.
Transmitter Operation
NOTE: This remote is equipped with 16 code combinations. To prevent possible interference
from or to other remote units such as garage door openers, car alarm or security system, simply
change the combination code but be sure that the code on both the hand held transmitter and
receiver in the fan are matched.
Install a 9 volt battery (not included).
Operating the Fan:
THE
Hi Key - High Speed
CODE
Fan Off Key - Fan Off
Reverse Key - Fan Reversing Function
Med Key - Medium Speed
Light Key - Light On/Off and Dimmer
Low Key - Low Speed