Making The Electrical Connections - HAMPTON BAY Tropics Manual Del Propietário

Installing Fan to
the Outlet Box
1. Pass the 120-volt supply wires through the
center hole in the ceiling mounting plate as
shown in Figure 5.
2. Install the ceiling mounting plate on the
outlet box by sliding the mounting plate
over the two screws provided with the
outlet box (Figure 5). If necessary, use
leveling washers (not included) between the
mounting plate and the outlet box. Note that
the flat side of the mounting plate is toward
the outlet box (Figure 5).
3. Securely tighten the two mounting screws.
4. Carefully lift the assembly up to the ceiling
mounting plate. Make sure the tab on the
mounting plate socket is properly seated in
the groove in the hanger ball.
Making the Electrical
Connections
REMEMBER to disconnect the power. If
you feel you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
Follow the steps below to connect the fan
to your household wiring. Use the wire
connecting nuts supplied with your fan. Se-
cure the connectors with electrical tape.
Make sure there are no loose strands or
connections (Figure 6).
1. Insert the receiver into the ceiling mounting
plate with the flat side of the receiver facing
the ceiling.
2. Connect both green wires from the down-
rod and mounting plate to the bare copper
(Ground) from the outlet box
3. Connect the black wire (AC IN L) from
the receiver unit to the black wire from the
outlet box.
4. Connect the white wire (AC IN N) from
the receiver unit to the white wire from the
outlet box.
5. Connect the white wire (To Motor N) from
the receiver unit to the white wire from the
fan assembly.
6. Connect the black wire (To Motor L) from
the receiver unit to the black wire from the
fan assembly.
7. Connect the blue wire (For Light) from the
receiver unit to the blue wire from the fan.
After wires are connected, carefully tuck them
into the outlet box. Insert the receiver unit into
the mounting plate; make sure the black anten-
na wire sits on top of the receiver unit.
THE FREQUENCIES ON YOUR RECEIVER AND
TRANSMITTER HAVE BEEN PRESET AT THE
FACTORY. BEFORE INSTALLING THE RECEIV-
ER, MAKE SURE THE DIP SWITCHES ON THE
RECEIVER AND TRANSMITTER ARE SET TO
THE SAME FREQUENCY. THE DIP SWITCHES
ON THE TRANSMITTER ARE LOCATED INSIDE
THE BATTERY COMPARTMENT.
EACH WIRE NUT (WIRE CONNECTOR) SUP-
PLIED WITH THIS FAN IS DESIGNED TO ACCEPT
UP TO ONE 12 GAUGE HOUSE WIRE AND TWO
WIRES FROM THE FAN. IF YOU HAVE LARGER
THAN 12 GAUGE HOUSE WIRING OR MORE
THAN ONE HOUSE WIRE TO CONNECT TO THE
FAN WIRING, CONSULT AN ELECTRICIAN FOR
THE PROPER SIZE WIRE NUTS TO USE.
5.