Westin 25-2770 Manual Del Instrucciones

AUTOMOTIVE PRODUCTS, INC.
STEP BAR ASSEMBLIES
ENSAMBLES DE ESTRIBOS
MONTAGES DE MARCHE-PIEDS
25-2770
25-2775
26-2770
26-2775
ITEM QTY
1,2 2 STEP BAR, PASSENGER (1) AND DRIVER (2)
3 1 FRONT PASSENGER BRACKET
4 1 FRONT DRIVER BRACKET
5 4 CENTER/REAR BRACKET
6 12 3/8-16 X 1.00" BUTTON HEAD BOLT
7 12 3/8" INTERNAL TOOTH LOCK WASHER
8 12 M8-1.25 X 30MM HEX HEAD BOLT
9 12 3/8" FLAT WASHER
10 12 3/8" LOCK WASHER
1,2 2 ESTRIBOS, LADO DEL ACOMPAÑANTE
3 1 SOPORTES
4 1 SOPORTES
5 4 SOPORTE
6 12 PERNOS TERMINALES DE 3/8 -16 x 1"
7 12 ARANDELAS DE PRESIÓN DE DENTADO INTERIOR DE 3/8"
8 12 PERNOS CON CABEZA HEXAGONAL M8-1,25 X 30MM
9 12 ARANDELAS PLANAS DE
10 12 ARANDELAS DE PRESIÓN DE
1,2 2 MARCHE-PIEDS, PASSAGER
3 1 SUPPORT AVANT PASSAGER
4 1 SUPPORT AVANT
5 4 SUPPORT CENTRAL/ARRIERE
6 12 BOULON A TETE RONDE DE 3/8-16 X 1,00 PO
7 12 RONDELLE A FREIN A DENTS INTERIEURES DE 3/8 PO
8 12 BOULON A TETE HEXAGONALE M8-1,25 X 30MM
9 12 RONDELLE PLATE 3/8 PO
10 12 RONDELLE A FREIN DE 3/8 PO
STEP 1.
Remove the contents from box and check for damage. Verify all parts are present. Read instructions completely before
beginning.
STEP 2.
Attach passenger side brackets to underside of body panel using two M8-1.25 x 30mm hex head bolts, 3/8" flat washers,
and 3/8" lock washers per bracket. Hand tighten.
STEP 3.
Attach passenger side step bar to cradles with the
the bend goes to the rear of the vehicle.
STEP 4.
Make sure step bar and brackets are properly aligned with vehicle and tighten fasteners. Recommended torque values are
26 FT.LBS. for 3/8" and 23 FT.LBS. for 8mm bolts.
STEP 5.
Repeat installation for driver side.
FINISH PROTECTION
Westin products have a high quality finish that must be cared for like any other exposed finish on the vehicle. Protect the finish with a non-abrasive automotive wax, (e.g.
Pure Carnauba) on a regular basis. The use of any soap, polish or wax that contains an abrasive is detrimental, as the compounds scratch the finish and open it to
corrosion.
PASO 1.
Retire el contenido de la caja y verifique que ninguna pieza se haya dañado. Verifique que no falte ninguna
pieza. Lea las instrucciones completamente antes de comenzar.
PASO 2.
Instale el soporte
M8-1.25 x 30 mm, las arandelas planas de 3/8" y las arandelas de presión de 3/8" por cada soporte. Apriete con la mano.
VEA LA FIGURA 1.
PASO 3.
Instale el estribo lado del
INSTRUCTIONS-INSTRUCCIONES-CONSIGNES
APPLICATION: 2005-07 TOYOTA TACOMA DOUBLE CAB
APLICACIÓN:
APPLICATION:
2
DRIVER SIDE
LADO DEL CONDUCTOR
COTE CONDUCTEUR
CONTENTS - CONTENIDO
DELANTERAS ACOMPAÑANTE
DELANTERAS CONDUCTOR
CENTRAL/ TRASERAS
3/8"
3/8"
(1) ET CONDUCTEUR (2)
CONDUCTEUR
lado del acompañate en la parte inferior del panel de la carrocería
acompañate sobre la base de modo que el logotipo de
TOYOTA TACOMA DOBLE CABINA
TOYOTA TACOMA DOUBLE CABINE
3
PASSENGER SIDE
LADO DEL ACOMPAÑANTE
COTE PASSAGER
1
- CONTENU
(1) Y EL CONDUCTOR (2)
SEE FIGURE 1.
Westin
logo facing outward.
, MOD. 2005-07
, 2005-07
4
TOOLS - HERRAMIENTA
7/32 HEX WRENCH
13MM SOCKET
13MM WRENCH
RATCHET
RATCHET EXTENSION
TORQUE WRENCH
LLAVE HEXAGONALE DE 7/32¨
DADO DE 13MM
LLAVE DE TUERCAS DE 13MM
MANERAL
MANERAL EXTENSION
LLAVE DE TORQUE
CLE HEXAGONALE 7/32 PO
DOUILLE 13MM
CLE 13MM
CLIQUET
RALLONGE DE DOUILLE
CLE DE COUPLE
SEE FIGURE 2.
The step pad closer to
a usando dos pernos hexagonales de
Westin
quede hacia afuera.
WO:
75-0827 REVISION 5/9/07
5
- OUTILS
VEA LA