Kobalt KCS 1224B-03 Manual De Instrucciones página 18

OPERATING INSTRUCTIONS
10. Bucking A Log
Bucking is cutting a log into lengths. It is important
to make sure your footing is firm and your weight is
evenly distributed on both feet. When possible, the
log should be raised and supported by the use of
limbs, logs or chocks. Follow the simple directions
for easy cutting.
WARNING
• Keep a clear-cutting area. Make sure that no
objects can contact the guide bar nose and chain
during cutting; this can cause kickback.
Overbucking
Begin on the top side of the log with the bottom
of the saw against the log; exert light pressure
downward. Note that the saw will tend to pull away
from you.
Underbucking
Begin on the underside of the log with the top of the
saw against the log; exert light pressure upward.
During underbucking, the saw will tend to push
back at you. Be prepared for this reaction and hold
the saw firmly to maintain control.
• When the log is supported along its entire length,
it should be cut from the top (overbucking) (Fig.
10c).
• When the log is supported on only one end,
cut 1/3 the diameter from the underside
(underbucking). Then make the finishing cut by
overbucking to meet the first cut (Fig. 10d).
10a
Overbucking
10b
Underbucking
10c
Log supported along the entire length
10d
2nd cut overbuck (2/3 diameter)
to meet 1st cut (to avoid
pinching)
1st cut underbuck (1/3 diameter) to
avoid splintering
18
Cut from top (overbuck)
avoid cutting earth
Log supported one end