Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO USE YOUR
PRESSURE WASHER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at 1=800=317-7833.
Pressure Washer
Location
Pressure Washer
Clearance
WARNING
" Keep at least 5 ft. (152 cm) clearance on all sides of pressure
washer including overhead.
Place pressure washer outdoors.
DO NOT place pressure
washer where exhaust gas could accumulate and enter
inside or be drawn into a potentially
occupied building.
Ensure exhaust gas is kept away from any windows, doors,
ventilation
intakes or other openings that can allow exhaust
gas to collect in a confined area (Figure 7). Prevailing winds
and air currents should be taken into consideration
when
positioning
pressure washer.
WARNING
. Operate
pressure washer
ONLY outdoors.
. Keep exhaust gas from entering
a confined area through
windows, doors, ventilation
intakes or other openings.
. DO NOT operate pressure washer inside any building or
enclosure, even if doors or windows
are open.
Typical Pressure
Washer
Shown
Exhaust Port
How
to
Start
Pressure
Washer
To start your pressure
washer
for the first time, follow
these
instructions
step-by-step.This
starting information
also applies if you have let the pressure
washer
sit idle for
at least a day.
1.
Place pressure
washer
near an outside
water
source
capable of supplying water
at a flow rate greater
than
3.7 gallons per minute
and no less than 20 PSI at
pressure
washer
end of garden
hose.
2.
Check
that high pressure
hose is tightly connected
to
spray gun and pump. See "Preparing
Pressure Washer
for Use" for illustrations.
3.
Make sure unit is in level position.
4.
Connect
garden
hose to water
inlet on pressure
washer
pump.
5.
Turn ON water, point gun in a safe direction
and squeeze
trigger to purge pump system of air and impurities.
CAUTION
.
Damage to equipment resulting from failure to follow this
instruction will void warranty.
Attach
nozzle extension
to spray gun (Figure 8).
Tighten
by hand.
7.
Place colored
quick connect
spray tips in slots on
holder
that's attached
to nozzle extension
(Figure 9).
8.
Choose
spray tip you want to use and insert it into
nozzle extension.
See "How to Use Spray Tips".
9.
Engage trigger lock to spray gun trigger (Figure IO).
Trigger Lock
Publicidad
