Publicidad
Idiomas disponibles
Idiomas disponibles
Connect
I-lose
and Water
Supply
to
Pump
IMPORTANT:
To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
1.
Uncoil high pressure hose and attach one end of hose
to base of spray gun (Figure 4).Tighten
by hand.
.
Attach
other
end of high pressure
hose to high
pressure
outlet
on pump (Figure 5).Tighten
by hand.
.
Before connecting
garden
hose to water
inlet, inspect
inJet screen
(Figure 6). Clean screen if it contains
debris
or replace if damaged. Refer to "O-Ring
Maintenance"
section
if inlet screen is damaged. DO NOT run
pressure
washer
if inlet screen is damaged.
4.
Run water
through
your garden
hose for 30 seconds
to clean out any debris.
IMPORTANT:
DO NOT siphon
standing
water for the
water
supply. Use ONLY cold water
(less than I00°F).
5.
Connect
garden
hose (not to exceed
50 feet in length)
to water
inlet.Tighten
by hand (Figure 6).
CAUTION
.
Damage
to equipment
resulting
from failure to follow this
instruction
will void warranty.
Turn ON water, point gun in a safe direction
and
squeeze
trigger
to purge pump system
of air and
impurities.
WARNING
Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate safety goggles.
Checklist
Before
Starting
Engine
Review the unit's assembly to ensure you have performed
all of the following.
I.
Make sure handle is in place and secure.
2.
Check that oil has been added to proper level in
engine crankcase.
3.
Add proper
fuel to fuel tank.
4.
Check
for properly
tightened
hose connections.
5.
Check
to make sure that there
are no kinks, cuts, or
damage to the high pressure
hose.
6.
Provide a proper
water
supply at an adequate
flow.
7.
Be sure to read "Safety Rules" and "HowTo
UseYour
Pressure
Washer"
before
using the pressure
washer.
Publicidad
