Selecting The Remote Controller Custom Code - Fujitsu AUHG24LVLA Manual De Usuario

SELECTING THE REMOTE CONTROLLER CUSTOM CODE

When two or more air conditioners are installed in a room and the Remote Controller is operating an air conditioner other than
the one you wish to set, change the custom code of the Remote Controller to operate only the air conditioner you wish to set
(4 selections possible).
When two or more air conditioners are installed in a room, please contact your retailer to set the individual air conditioner custom
codes.
Selecting the Remote Controller Custom Code
Use the following steps to select the custom code of the remote controller. (Note that
the air conditioner cannot receive a signal if the air conditioner has not been set for the
matching custom code.)
1
Press the START/STOP button until only the clock is
displayed on the remote controller display.
2
Press the MODE button for at least fi ve seconds to
display the current custom code (initially set to ).
3
Press the
(
between
the air conditioner custom code.
4
Press the MODE button again to return to the clock
display. The custom code will be changed.
If no buttons are pressed within 30 seconds after the custom code is displayed, the system returns to the original clock dis-
●
play. In this case, start again from step 1.
The air conditioner custom code is set to "A" prior to shipment. Contact your retailer to change the custom code.
●
The Remote Controller resets to custom code "A" when the batteries in the Remote Controller are replaced. If you use a
●
custom code other than custom code "A", reset the custom code after replacing the batteries.
If you do not know the air conditioner custom code setting, try each of the custom codes (
code which operates the air conditioner.
buttons to change the custom code
/ )
. Match the code on the display to
) until you fi nd the
En-13