H.Koenig MX15 Manual De Utilización página 3

 Switch off the unit before pulling out the mains plug.

Avoid to potential injury from misuse

Switch off the appliance and disconnect from supply before changing accessories or approaching parts that move in use.
 Use only spare parts from the manufacturer or his local dealer.
 Never carry the unit by its power cord.
 Do not remove individual housing components.
 Caution: the appliance is in stand-by mode while it remains connected to the mains supply. Keep out of reach of
children or persons requiring supervision.

Care shall be taken when handling the sharp cutting blades, emptying the bowl and during cleaning.
 When mixing hot liquids/foods excess pressure may build up inside the blender, and this could make the lid come
off and the contents splash out. We therefore recommend that you avoid mixing excessively hot foods and that you
only put very small quantities of hot liquids or foods into the blender.
 Do not use the blender for very hard food products, such as bones, shelled nuts, frozen meats etc., which could
either damage the blade or cause the motor to seize.
Caution:
Switch off the unit before clean it to avoid dangers. When the plug or
power cord have damage, do not use the unit, even not to disassembly by
yourself, must be inform the after- service center to handle.
SPECIAL SECURITY PRECAUTIONS
 Caution: The blades of the jug are very sharp. There is a danger of injury! While the blades are turning, never
touch the jug from the inside and never put any objects inside.
 Only use equipment endorsed by the manufacturer.
 Only use the unit with tightly closed lid and inserted closure.
 The unit is equipped with a security function. The unit can only be switched on if the jug is put on the engine
base properly. If the unit cannot be switched on, pull the power cable and check the connection between jug
and engine base.
1． Clean the Measuring cup, Lid and Blending glass cup (except main body) and so on before first using.
2． To make sure the unit is turned off and not to connect before installation.
PARTS ITEM
Installation