Craftsman BANDSAW 119.214000 Manual De Usario página 5

d.Place t heblade tension k nob ontotheblade tensioner (See
Fig. 4 ).
b.Fasten t heguide rail w ithtwoeach starknob screw andwasher
tothetable. U se thehexsocket head capscrew, washer andwing
nutforcorrecting theworking t able flatness. (See Fig.2)
FIG. 2
c. Lay the rip fence onto the guide rail. Adjust the rip fence parallel
to the saw blade. Tighten rip fence handle by pressing downward.
(See Fig. 3)
FIG, 4
e. To ensure sufficient upright stability of the machine it should be
bolted to floor, bench or worktable. For this purpose 6mm holes
are provided in the machine's base. (See Fig. 5)
FIG. 5
f. The bandsaw has a 2-1/2" dust port included. (Sea Fig. 6)
It is recommended that when in use, the bandsaw is connected to
a suitable dust collector.
!"
FIG. 6
tension knob
=g knob
]uide
T
_Blade rack ng knob
'Guide post adjusting knob
_. _ ,
Look
Lower tabl
Dust