DeWalt P3600 Instrucciones De Funcionamiento página 6

P3600
BASE MATERIAL THICKNESS
Steel base materials should be a minimum of 1/8" (3mm) in thickness.
1/8"
EDGE DISTANCE
For installations in A 36 steel, 1/2" (13mm) is the recommended minimum edge distance.
SPACING
1/2"
The recommended minimum distance between fastenings is 1-1/2" (38mm) center to
center for installations in ASTM A 36 steel.
FASTENER LENGTH SELECTION IN STEEL
1-1/2"
For permanent applications when using pins in steel, first determine the thickness of
the fixture to be fastened. To this, add the thickness of the steel base material plus a
minimum of 1/4" (6mm) to allow for proper point penetration. This will be the minimum
fastener shank length required. Do not select a fastener length longer than that
required for the application.
For removable applications with threaded studs, the shank length required is equal
to the thickness of the steel base material plus a minimum of 1/4" (6mm) to allow for
proper point penetration. This will be the minimum fastener shank length required. Do
not select a shank length longer than that required for the application. An excessively
long shank can burnish or polish the hole created in the steel resulting in a reduction
in load capacity. To determine the minimum threaded length, add the thickness of the
fixture and the nut / washer thickness. The nut and washer thickness is equal to the
nominal thread diameter.
Do not over tighten threaded studs, the maximum tightening torque is listed in
the table below. Use of a nut setter is recommended to reduce the possibility of over
tightening the fasteners. For critical applications, perform a job site test.
POWDER LOAD SELECTION GUIDE
.27 CALIBER 10 LOAD STRIP
CAT #
50606-PWR
.27 CALIBER SAFETY STRIP
#
50626-PWR
50630-PWR
FASTENER SELECTION GUIDE
3/8" -16 THREADED STUDS
CAT #
50340-PWR
50342-PWR
50344-PWR
K=Knurled
POWER LEVEL LOAD COLOR
6 Purple
®
POWER LEVEL LOAD COLOR
4 Yellow
5 Red
THREAD LEN SHANK LEN
1-1/4" 3/4" K
†
1-1/4" 1"
†
1-1/4" 1-1/4"
†
† Factory Mutual Research Corp. approved for Pipe Hanger Components
SIZE BOX CTN
.27 strip 100 1000 10,000
SIZE BOX CTN
.27 100 1000 10,000
.27 strip 100 1000 10,000
THREAD DIA SHANK DIA
3/8" .205
3/8" .205
3/8" .205
EN
6
MSTR CTN WT./ 100
.33
MSTR CTN WT./ 100
.37
.33
CTN MSTR CTN
100 1000
100 1000
100 1000