Tripp-Lite B024-DUA8-SL Manual Del Propietário página 12

Installation
Note: Before making any connections, make sure power to all devices being connected to the
KVM switch are turned off. Unplug any computer power cords using the Keyboard Power-On
function.
1
Connect a monitor to the KVM using one of the three following methods.
a. DVI Monitor – Connect the DVI port on the monitor to the DVI-I console port
located on the rear of the KVM switch.
b. DVI + VGA Monitor – For monitors with DVI and VGA ports, you can connect
both to the KVM switch. Connect the DVI port on the monitor to the KVM's
DVI-I console port, and the VGA port on the monitor to the KVM's VGA console
port.
c. DVI and VGA Monitors – Connect a DVI monitor to the DVI-I console port on
the KVM, and a VGA monitor to the VGA console port.
Note: Only one video signal will transmit at a time. When connecting to both the DVI and
VGA ports on a single monitor, or when connecting DVI and VGA monitors at the same
time, the video output used will be determined by the OSD settings. See the Set Computer
Video Input section in this manual for details.
2
Connect a USB keyboard and mouse to the corresponding USB keyboard and
mouse console ports located on the rear panel of the first level KVM switch.
3
Optional – Connect a microphone and speakers to the corresponding 3.5 mm
console jacks on the unit's front or rear panel. The front panel jacks will take
priority over those on the rear panel.
4
Optional – Connect USB device(s) to the USB 2.0 hub port(s) on the front and
rear panels of the KVM switch.
Note: In a cascade installation, USB 2.0 hub functionality is not available to the second or
third levels of KVM switches.
5
Connect the KVM cable kit to the KVM switch. The USB-B male connector side
plugs in to an available set of computer ports on the unit's rear panel. Connect
the DVI-D connector to the DVI-I port, and the USB and 3.5 mm connectors to its
corresponding USB and 3.5 mm ports.
Note: KVMs include two 6 ft. cable kits. For the remaining ports requiring cables, or if a
longer cable is needed, separate P759-Series DVI/USB + Audio KVM Cable Kits are needed
(sold separately).
6
Connect the other end of the KVM cable kit to the console ports of a second level
KVM switch.
Note: Connect the USB-A male connector to the top USB-A console port (labeled for mouse
functionality) on the second level KVM switch.
7
Repeat steps 5 and 6 for each additional KVM switch added to the installation.
Up to 8 second-level KVM switches and up to 64 third level KVM switches can be
connected.
17-10-479-93370A.indb 12
12
11/17/2017 2:29:00 PM