Tripp-Lite B024-DUA8-SL Manual Del Propietário página 25

Basic Operation
SET CONSOLE
VIDEO OUTPUT
MOUSE
EMULATION
ACTIVATE
MULTIVIEW
OSD CONFIG
BACKUP /
RESTORE
SET LOGIN
MODE
17-10-479-93370A.indb 25
Sets the console video output type. If the computer attached
to the KVM is VGA output, this can be set to display on either a
VGA or DVI console monitor.
Options are:
• DVI-A to VGA – select this option if there is one DVI monitor
with a DVI-D plus VGA connector, or if there are two monitors
(1 x DVI, 1 x VGA)
• DVI-A to DVI-I – select this option if there is one DVI monitor
with a DVI-I connector
Note: In a cascade installation or if using a VGA-to-DVI adapter in your
installation, select DVI-A to DVI-I
Enables / disables the mouse emulation function.
Note: Mouse emulation is supported in the first level of an installation
only.
Enables multi-view mode for dual-, triple- or quad-monitor
viewing in a multiple monitor installation where each computer
is fitted with multiple video cards (see the Multi-Monitor
Installation section in this manual for details).
Note: Multi-view mode must be enabled on the OSD before setting up a
multi-monitor installation.
Enters OSD Configuration Backup / Restore mode. The
Firmware Management Utility allows back up of the current OSD
configuration and restore capability, when necessary. Storing
the OSD configuration settings is useful when deploying more
than one installation that uses the same settings (see the OSD
Configuration Backup/Restore section in this manual for
details).
This function allows the Administrator to determine which users
are required to log in to the KVM with a username and password.
When disabled, the system disables the login/logout function.
25
11/17/2017 2:29:03 PM