Initial Use; Normal Operation - Zuvo 100 Serie Manual Del Usuario

Initial Use

The Zuvo Water Filtration System must be plugged into
an electrical outlet to operate.
NOTE: Do not use an outlet that is intended for a
garbage disposal as power to this outlet is controlled by
a switch.
For countertop installations, after you install your
Zuvo Water Filtration System or replace the filter
always allow COLD water to flow through the
system according to the operating instructions
below before drinking or using the water. Never
flush or operate the Zuvo system with hot water.
The Zuvo system includes a filter and will alert you that
an initial filter flush is needed by beeping FOUR times
every 30 seconds until the faucet is turned ON.
For an under-counter installation, turn on the Zuvo
Beverage Faucet to light up the UV lamp and initiate
water flow through the Zuvo Water Filtration System.
You should observe an upward swirling motion of water
and a constant stream of bubbles when the system is
illuminated and working properly.
For a countertop installation, turn on your main faucet
and open the valve on the diverter to light up the UV
lamp and initiate water flow through the system.
Once you turn the faucet ON and while the system
is flushing, the system will beep ONE time every 10
seconds.
When the Zuvo system stops beeping every 10 seconds,
the system is ready and the faucet can be turned OFF.

Normal Operation

When there are more than two weeks (based on typical
use) of filter capacity remaining, the Zuvo system will be
silent (no beeps) when the Zuvo faucet is ON or OFF.
Less than Two Weeks or Approximately 40 Gallons
of Filter Capacity Remain (Typical Usage)
Once there are less than two weeks or approximately
40 gallons of filter capacity remaining, the Zuvo system
will beep TWO times whenever the Zuvo faucet is
turned ON. This is a reminder that the filter needs to be
changed soon.
The Zuvo system will be silent (no beeps) when the
Zuvo faucet is OFF.
Filter Replacement Needed
After two weeks have passed or approximately 40 gallons
of filter capacity have been depleted, the Zuvo system will
beep THREE times whenever the Zuvo faucet is turned
ON. This is a reminder that the filter needs to be changed
immediately.
The Zuvo system will be silent (no beeps) when the Zuvo
faucet is OFF.
Unit with New Filter
After a new filter is installed in the Zuvo system, it will
beep FOUR times every 30 seconds until the Zuvo
faucet is turned ON. This is a reminder that the Zuvo
system needs to be flushed with COLD water prior to
drinking or using the water. When you turn the faucet
ON, the system will begin flushing and beep ONE time
every 10 seconds. Once the Zuvo system stops beeping
every 10 seconds, the system is ready and the faucet
can be turned OFF.
System Trouble Found
If system trouble is found, the Zuvo system will beep
FIVE times every 30 seconds. Possible problems include:
Problem
System needs to be rebooted
Filter unknown
Water on too long
(courtesy warning) if on for
more than 5 gallons
UV lamp life exceeded
Action
Unplug system and plug back in
Unplug system, remove filter, rotate ¼
turn, install filter, plug system back in
Turn off water
Order replacement lamp from supplier
and replace lamp assembly
Page 5