How To Replace Filter - Zuvo 100 Serie Manual Del Usuario

How To Replace Filter

WARNING
It is extremely important that the unit be
unplugged. The Zuvo Water Filtration System
contains a high-intensity ultraviolet (UV) light that
can damage tissues in the eye. The UV light cannot
travel through the plastic housing.
However, removing the filter requires that the
top cap be removed, exposing the lamp. Do not
proceed without unplugging the unit!
For the filter to be removed, the filter and all
internal seals must be wet. Do not attempt to remove
a dry filter. Doing so may result in breakage of the UV
lamp.
1. Unplug unit: Always
unplug unit before
opening the top cap.
Failure to do so could
result in exposure to
ultraviolet light which
is harmful to eyes.
2. P ull both clamps
upward and
evenly.
3. P ull both locking
tabs outward.
Page 6
4. Pull both locking
tabs down.
5. Rotate top cap to
expose filter cover.
6. Wrap a towel around the
bottom of the reservoir so
that water doesn't drip down
into the white base.
Pull out filter by pulling
straight up.
7. Prior to installing
new filter, wet lower
O-ring with water to
allow the filter to
slide in easier, and
then simply reverse
the above steps to
re-seal the unit.
8. Flush the system with cold tap water according to
the operating instructions in this manual before use.
Never flush or operate the unit with hot water.