Cadet F Serie BTF1 Instrucciones De Instalación página 2

READ ALL INSTRUC-
TIONS AND SAFETY
INFORMATION.
WARNING!
RISK OF
ELECTRICAL
SHOCK. TURN OFF
ALL POWER AT
THE ELECTRICAL
PANEL BOARD
SUPPLYING
POWER TO THE
HEATER BEFORE
DOING ANY ELEC-
TRICAL WIRING.
IMPORTANT!
IT IS EXTREMELY
IMPORTANT THAT
YOU VERIFY THE
ELECTRICAL SUPPLY
WIRES ARE THE
SAME VOLTAGE AS
THE HEATER (I.E. 120
VOLT HEATER TO 120
VOLT POWER
SUPPLY AND 240
VOLT HEATER TO
240 VOLT POWER
SUPPLY).
INSTALLATION INSTRUCTIONS
SINGLE HEATER WIRING
BTF1 – 240/208V and 120V
Cut only one factory splice on base-
board heater: A, B, or C (refer to Figure
1). Connect one supply wire to the red
thermostat wire. Connect black thermo-
stat wire to one heater wire. Be sure the
other supply wire is connected directly
to the heater wire. Connect Ground.
BTF2 – 240/208V only
Cut only one factory splice on
baseboard heater: A, B, or C (refer to
Figure 1). Connect one black thermostat
wire to one heater wire. Connect
remaining black wire to remaining
heater wire. Connect one supply wire to
red thermostat wire. Connect remaining
supply wire to remaining red wire.
Connect ground.
BTF2 – 120V only
Connect the supply hot wire (typically
black) to a red thermostat wire (refer to
small numbers on back of BTF2 switch).
Connect the neutral supply wire (typical-
ly white) to a red thermostat wire. Cut
only one factory splice on baseboard
heater: A, B, or C (Refer to Figure 1).
Connect the remaining black thermostat
wires to each of the heater wires.
Connect Ground. All 4 wires must be
used.
MULTIPLE HEATER WIRING
More than one baseboard heater can be wired in
parallel on same circuit (Be sure to check nation-
al and local codes for safety requirements).
BTF1 - 120V or 240V Supply
Disconnect "A," "B" or "C" but only remove one
factory connector on each baseboard. (Left side
wiring: disconnect A or B, but not both. Right side
wiring: disconnect C only). Connect one supply
lead (hot for 120v) to the red thermostat wire.
Connect black thermostat wire to one wire on
each heater. Connect remaining wire from each
heater to the remaining supply lead (neutral for
120v). Connect ground wire to both heaters.
BTF2 - 120V or 240V Supply
Disconnect "A," "B" or "C" but only remove one
factory connector on each baseboard. (Left side
wiring: disconnect A or B, but not both. Right side
wiring: disconnect C only). Connect one supply
wire to each red thermostat wire. Connect one
black thermostat wire to one wire on each heater.
Connect remaining black thermostat wire to the
remaining wire on each heater. Connect ground to
both heaters.
BTF1 Wiring Diagram
RED
BLACK BLACK BLACK
RED
RED RED
GRD
BLACK
BTF2 Wiring Diagram
B
RED
BLACK
A
Figure 1
RED
RED
NOTE: Supply wire colors may vary. Reference to col-
ors assumes general standards.
SECTION OF WIRE
SECTIONS OF WIRE
NOT PROVIDED
SECTIONS OF WIRE
GRD
SECTION OF WIRE NOT PROVIDED
©2006 Cadet Manufacturing Co.
BLACK BLACK BLACK
RED
GRD
BLACK BLACK BLACK
C
NEGRO
RED
NOT PROVIDED
BTF1
NOT PROVIDED
RED RED RED
BLACK BLACK BLACK
GRD
RED RED RED
BTF2
BLACK
Printed in U.S.A. 10/06 #720107
RED
RED