Insert The Batteries Into The Training Computer; Functions Of The Training Computer - FitEngine M-05 Manual De Instrucciones

EN
3. Put the straight end of the pump in
the bucket and the fl exible end in the
water tank.
4. Pump water into the water tank until
the water reaches the maximum level
(see lines on the water tank).
Insert the Batteries into the
Training Computer
PLEASE NOTE!
■ Use only the battery type specifi ed in
the technical data.
■ Take the batteries out of the training
computer if they are dead or if you will
not be using the device for a pro-
longed period. This will prevent any
damage caused by leaks.
■ Remove leaking batteries from the
training computer immediately.
Before inserting the batteries, check
whether the contacts in the training com-
puter (3) and on the batteries are clean,
and clean them if necessary.
The battery compartment is located on the
back of the training computer:
1. grip and press down the locking lugs
on the battery compartment cover.
Open the battery compartment cover
at the same time.
2. Insert two batteries into the battery
compartment (1.5 V; AA). Make sure
the polarity (+ / –) is correct.
3. Close the battery compartment. When
you do this, make sure that the locking
lugs sit in the recesses which are
provided for them. The battery com-
partment cover must be heard to click
into place.
If the training computer stops working, the
batteries have to be replaced.
14
09605_Inlay_DE-EN-FR-ES-IT_A5.indb 14 09605_Inlay_DE-EN-FR-ES-IT_A5.indb 14
Functions of the Training
Computer
(Fig. C)
• The training computer (3) is switched
on by pressing the ON / OFF button
for about 3 seconds.
• In the upper left area the (extrapo-
lated) number of strokes per minute
SPM is displayed. If the movement
stops it displays 0.
• In the upper right section the display
can show CAL/H, TIME/500M and
SPEED in KM/H or MI/H. An average
value (AVG) is always calculated.
Press the relevant buttons to switch
between the displays.
• When the CAL/H, TIME/500M or
KM/H and MI/H displays fl ash during
exercise, all the values are shown
continuously for a few seconds.
• If one of the displays has been select-
ed via the buttons, both the unit and
the value are shown constantly on the
display.
Please Note: If a display has been
selected, the display cycle can only
be reset by resetting all the displays
(RESET).
• To change the SPEED display from
KM/H to MI/H or vice versa, press the
KM/MI button for approx. 5 seconds.
A beep sounds and all displays go off
and on again.
• In the lower left area the exercise time
(TIME) is displayed.
• In the lower right area the distance
(DIST) in km (K) is displayed.
• If the RESET key is pressed for
approx. 5 seconds, all the values are
reset to zero. A beep sounds and all
displays go off and on again.
• If there is no activity for approx. 2
minutes, the training computer will
automatically switch off .
04.08.2020 08:13:04 04.08.2020 08:13:04