Flue to the rear
with a low top
module
4. The two handles (included) are only
used for lifting and lowering the heat
storage elements. The handles are
removed after the heat accumulation
elements have been lowered in place.
They will not be needed again.
5. The regulator disk assembly is po-
sitioned so that it falls in place with
the three legs on the top module.
The regulator disks are constructed
so that the regulation lever may be
placed to the right or to the left.
When the flue is upwards, the centre
piece must be removed. The three
small bridges may be cut with a hack-
saw blade.
Finally, the top cover is put in place
so that it rests on the three legs on
the top module.
Flue upwards with a
low top module
Flue to the rear
with a tall top
module
Flue to the rear
Flue upwards with a
tall top module
Flue upwards
7