Setting System Address; Setting Tool Address; Setting Turn Off Time - IVAC Pro TOOL Guia Del Usuario

6.2 Setting System Address

It should be noted that for 'iVAC Pro Tool' and 'iVAC Pro
Switch' units to work together they must be set to the same
System Address. Both the 'iVAC Pro Tool' and 'iVAC Pro Switch'
are shipped with the system address set at Address A. This can
be changed if there is a clash with an adjacent system or if
two systems are used in the same workshop.
The System Address is set by means of positions 1 and 2 on
the Program Switch.

6.3 Setting Tool Address

This applies to 'iVAC Pro Tools' only.
In the case of a set up where there is more than one 'iVAC Pro
Tool' in a system, each 'iVAC Pro Tool' must have a unique
Tool Address set in the range of 1 to 8.
The Tool Address is set by means of positions 4, 5, and 6 on
the Program Switch.

6.4 Setting Turn Off Time

This feature applies to the 'iVAC Pro Switch' only. After the
'iVAC Pro Switch' has been instructed to turn off by an 'iVAC