Battery Removal - Remington Ladyshaver WDF5030 Manual Del Usuario

ENGLISH
, SIGNS THAT YOUR FOILS AND CUTTERS NEED REPLACING
• Irritation: as foils get worn, you may experience skin irritation.
• Pulling: as the cutters wear, your shave may not feel as close and you may
feel the cutter pulling through your hair.
• Wear through: you may notice that the cutters have worn through the foils.
, TO REPLACE THE FOIL
• Ensure the shaver is switched off.
• Firmly press the foil holder release buttons at either end of the foil. The foil
holder should then easily detach from the head assembly.
• Hold the foil holder with the foils facing towards you. Place your thumbs on
each side of the foil plastic guards and press firmly until the foil snaps free.
• Repeat this for the second foil.
• To reassemble turn over the foil holder. Position the new replacement foils
in the foil holder and pressing gently, click them into place.
• Reassemble the foil holder and the shaver head by securely snapping in
place.
, CAUTION
• Only hold the plastic to prevent damage to the foil.
• Do not press on the foil when replacing.
, REPLACING THE CUTTERS
• Ensure the shaver is switched off and open the foil holder (as above).
• Grasp the flat edges of the cutter between your thumb and forefinger and
pull upwards.
• To reassemble the cutter, insert the protruding pin on the shaver head into
the hole in the middle of the cutter. Gently push the cutter down, until it
clicks in place.
• Reassemble the foil holder and shaver head by securely snapping in place.

BATTERY REMOVAL

• The battery must be removed from the appliance before it is scrapped.
• The appliance must be removed from the charging stand when removing
the battery.
• Ensure the battery is discharged.
• On the back of the shaver, press the shaving head release button to the
right, grip the head and remove the shaving head.
• Using a small screwdriver, remove the 4 screws from the inside top of the
shaver and the single screw from the bottom of the shaver.
7