OHAUS SD Serie Manual De Instrucciones página 8

EN-4 SD SERIES BENCH SCALE
• Bracket Wall Mounting/Table Mounting:
Attach the two mounting brackets as shown in Figure 4. Position the
Indicator where desired on the wall or table. Install 2 screws (not supplied)
into the ends of each bracket to secure them to the surface. When mounting
to a wall without solid backing, use appropriate anchoring hardware.
MOUNTING NOTES:
1. When attaching brackets: Insert round pins into holes at bottom of
2. Mounting brackets may be attached in two different orientations to provide
3. Some mounting positions may require that the brackets be attached to the
1.800.544.2843
Figure 3. Direct Wall Mount Arrangement.
Indicator, slide each bracket back to lock in place.
optimum viewing angle.
work surface before being attached to the indicator.
Figure 4. Bracket Wall & Table Mount Arrangements.
www.calcert.com
15
10 20
5 25
0 30
120mm / 4.72"
120mm / 4.72"
sales@calcert.com