General Notes - RCBS 87006 Instrucciones Del Producto

DRYING INSTRUCTIONS
Once the media has been separated from the brass, the brass will still need to be dried.
1. Lay the brass on a towel and periodically roll the brass over to ensure complete uniform drying.
TIP: Place a fan at one end of the towel to force air across the brass. Or use a blow dryer (low or medium
setting) to dry the brass by moving it back and forth over the brass.

GENERAL NOTES:

1. Stainless Steel Pins should be cleaned and dried, and should be stored in a dry location.
• If pins develop rust or corrosion, cleaning the pins in the brass cleaning solution and water will help
remove it.
2. All Cleaner parts should be stored in a clean and dry condition for optimal life.
3. The Cleaner must be used on a flat hard surface .
• Optimal Cleaner location is on a concrete floor.
• Do not use the Cleaner on carpet.
• Do not use Cleaner on a table, table top, work bench, or elevated surface, as the Cleaner may vibrate
and "walk off" of an elevated surface.
4. Be careful not to set the Drum on top of an elevated surface, as it may roll off and become damaged.
5. All brass cases should be carefully and individually checked, to ensure that all stainless steel pins have been
removed from the inside of the case.
6. DO NOT leave brass soaking in the cleaning solution for prolonged periods, as the brass will start to
become discolored.
WARNING: KEEP YOUR HANDS, HAIR AND ALL LOOSE CLOTHING AWAY FROM THE ROLLERS. THEY MAY
PULL, GRAB OR PINCH NEARBY OBJECTS WHEN THEY ARE IN MOTION.
9