Craftsman BOLT ON 34980 Manual Del Operador página 3

• Do not "jam" the cut-off saw blade or apply excessive pressure. Do not attempt to make an
excessive depth of cut.
• Keep your hands away from cutting area. Do not reach under the material being cut.
• Do not use dull or damaged blades. Bent blade can break easily or cause kickback. Exercise
extreme caution when handling the accessories. The accessories are very sharp. Wear protective
gloves when changing cutting accessories. Accessories become hot after prolonged usage.
• Before scraping, check workpiece for nails. If there are nails, either remove them or set them well
below intended finished surface. Striking a nail with accessory edge could cause the tool to jump.
• Do not wet sand with this tool. Liquids entering the motor housing are an electrical shock hazard.
• Never work in area which is soaked with a liquid, such as a solvent or water, or dampened
such as newly applied wallpaper. There is an electrical shock hazard when working in such
conditions with a power tool and heating of the liquid caused by scraping action may cause harmful
vapors to be emitted from workpiece.
• Do not use sandpaper intended for larger sanding pads. Larger sandpaper will extend beyond
the sanding pad causing snagging, tearing of the paper or kick-back. Extra paper extending
beyond the sanding pad can also cause serious lacerations.
WARNING:
ALWAYS use safety glasses. Everyday eyeglasses are NOT safety glasses. Also
use face or dust mask. ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CPA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NOSH/OSHA respiratory protection.
WARNING:
Some dust created by power sanding, sawing, grinding, drilling, and other
construction activities contains chemicals known to the state of California to cause cancer, birth
defects or other reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment,
such as those dust masks that are specially designed to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and other
construction activities. Wear protective clothing and wash exposed areas with soap and
water. Allowing dust to get into your mouth, eyes, or lay on the skin may promote absorption of
harmful chemicals.
WARNING:
Use of this tool can generate and/or disperse dust, which may cause serious
and permanent respiratory or other injury. Always use NOSH/OSHA approved respiratory
protection appropriate for the dust exposure. Direct particles away from face and body.
WARNING:
Always wear proper personal hearing protection that conforms to ANSI
S12.6 (S3.19) during use. Under some conditions and duration of use, noise from this
product may contribute to hearing loss.
PRecAUTIONS TO TAKe WHeN SANDING PAINT
1. Sanding of lead based paint is NOT RECOMMENDED due to the difficulty of controlling the
contaminated dust. The greatest danger of lead poisoning is to children and pregnant women.
2. Since it is difficult to identify whether or not a paint contains lead without a chemical
analysis, we recommend the following precautions when sanding any paint:
PeRSONAl SAfeTy
1. No children or pregnant women should enter the work area where the paint sanding is being
done until all clean up is completed.
2. A dust mask or respirator should be worn by all persons entering the work area. The filter
should be replaced daily or whenever the wearer has difficulty breathing. See your local
hardware store for the proper N.I.O.S.H. approved dust mask.
3