Abnormity And Solution - Orima ORC-1003-C Libro De Instrucciones

(9).Abnormity and Solution

Fault
Light on, but motor
does not work
Light does not work,
motor does not work
Oil leakage
Shake of the body
Insufficient suction
The machine inclines The fixing screw not tight
Cause
The leaf blocked
The capacitor damaged
The motor jammed bearing
damaged
The internal with of motor off or
a bad smell from the motor
Beside the above mentioned, check the following:
Light damaged
Power cord looses
One way valve and the air
ventilation entrance are not
tightly sealed
Leakage from the connection
of U-shaped section and
cover
The leaf damaged and causes
shaking
The motor is not tightly
hanged
The body is not tightly
hanged
The distance between the
body and the gas top too long
Too much ventilation from
open doors or windows
enough
The hanging screw not tight
enough
37
Solution
Get rid of the blocking
Replace capacitor
Replace motor
Replace motor
Replace lights
Connect the wires as per
the electric diagram
Take down the one way
valve and seal with glue
Take U-shaped section
down and seal with soap
or paint
Replace the leaf
Lock the motor tightly
Fixed the body tightly
Readjust the distance
Choose a new place and
resemble the machine
Tighten the hanging
screw and make it
horizontal
Tighten the hanging
screw and make it
horizontal