Tools And Materials; Before You Begin - Kohler K-1528 Guia De Instalacion

Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few minutes to review this manual before
you start installation. If you encounter any installation or performance problems, please don't hesitate to
contact us. Our phone numbers and website are listed on the back cover. Thanks again for choosing Kohler
Company.

Tools and Materials

Safety Drill
Glasses
Claw
Hammer

Before You Begin

Observe all local plumbing and building codes.
Locate the rough plumbing for the drain in accordance with the roughing-in dimensions for your
particular model.
A variety of installations are possible. These instructions show suggested installation procedures,
your particular installation may require other construction techniques.
Please read these instructions carefully to familiarize yourself with the required tools, materials, and
installation sequences. Follow the sections that pertain to your particular installation. This will help
you to avoid costly mistakes.
Avoid flexing the side walls to prevent damage to the module.
Unpack and inspect the shower module for damage. If you find any damage, do not install the
module. Report the specific problem to your dealer immediately.
After inspection, return the shower module to the carton until you are ready to install it.
Insulate all exterior walls before installation.
You must install this shower module to an adequately supported, level subfloor.
Be sure that you have enough access to move the module into the construction area.
One-piece shower modules are too large to fit through standard door openings. This multi-piece
module is designed to be separated into sections for moving into the installation area. Once near the
installation area, reassemble the module and place it within the installation area prior to the
completion of framing.
Before installation, provide access to all connections. Because the module must be installed as an
assembled "one-piece" module, the drain and overflow connections cannot be made by reaching
over the end of the module.
Make sure the installation area is clean and free of all debris. If remodeling, remove all finished wall
material to expose the framing and remove all floor coverings to expose the subfloor.
1010416-2-C
Screwdriver
Pipe
Wrench
Square
Pencil
Tape
Measure
Plus:
• Common Woodworking
Tools and Materials
• Nails/Drywall Screws
• Drop Cloth
• 2 x 4s or 2 x 6s
Masking
Tape
• Water Resistant Wall Material
2
Level Sealant
• Knife
• Pliers
• Putty Knife
• Adjustable Wrench
• Clean Work Gloves
• Hole Saw
Plumbers
Putty
Kohler Co.