Tools And Materials; Before You Begin - Kohler K-702010 Guia De Instalacion

Tools and Materials

Safety Glasses
Drill & Assorted
Drill Bits

Before You Begin

CAUTION: Risk of personal injury. Always wear safety glasses while cutting or drilling.
NOTICE: Do not touch the edge of the tempered glass panel with tools or any hard objects. Do not set the
unframed tempered glass edge directly on the floor. This will reduce the risk of shattering.
NOTICE: Do not attempt to cut tempered glass. Tempered glass shatters when it is cut.
NOTICE: When using a retractable case tape measure, add the length of the case to the measurement or
measure in a manner that excludes the case.
NOTE: Record the model number on the Homeowners Guide. The proper model number will enable our
customer service representatives to quickly help you if needed.
Your new Kohler door can be installed with the door opening to either the right or left. Install the
door with the pivot side away from the showerhead for best results. These instructions show the
door installed with a left side swing. Doors that swing to the right would be opposite.
Before starting the installation, lay out and identify all of the parts. Inspect them for damage.
The shower receptor should be installed and prepared at this time, including finished wall materials.
Two hex wrenches, 5/32" and 5/64" are supplied. A 7/64" drill bit is also supplied.
Closely follow the instructions pertaining to the sealant application on the door. Sealing areas other
than those shown may cause leaking.
Two people should perform this installation.
Kohler Co. reserves the right to make revisions to the design of products without notice, as specified
in the Price Book.
1011451-2-F
Measuring Tape
Assorted Screwdrivers
Pencil
Miter Saw or Hack Saw with
32-teeth Per Inch Blade
2
Plus:
• Drop cloth
• Fine flat file
Level • Utility knife
Silicone Sealant
Kohler Co.