Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Pressure Washer Maintenance
Check and Clean Inlet Screen: Examine inlet screen
on pump inlet fitting. Clean if clogged; replace if torn.
Check High Pressure Hose: High pressure hose can
develop leaks from wear, kinking, abuse. Inspect hose
each time before use. Check for cuts, leaks, abrasions
or bulging of cover, and damage or movement of
couplings. If any of these conditions exist, replace hose
immediately.
Check Chemical/Soap Hose: Examine the
chemical/soap hose and clean if clogged. Hose should
fit tightly on pump fitting. Check for leaks and tears.
Replace filter or hose if either is damaged.
Check Gun and Wand: Examine hose connection to
gun making sure it is secure. Test trigger by pressing it
and making sure it springs back into place when you
release it.
Pump Maintenance
(Changing Pump Oil)
Your pressure washer pump is a sealed pump, you
should never have to change oil.
Purge Pump of Air and Contaminants
To remove the air from the pump, follow these steps:
•
Set up the pressure washer as described in
ASSEMBLY section and connect the water supply.
•
Remove the wand extension from the spray gun.
•
Pull the trigger on the gun and hold.
To remove the contaminants from the pump, follow
these steps:
•
Set up the pressure washer as described in
ASSEMBLY section, connect the water supply.
•
Remove the wand extension from the spray gun.
•
Start the engine according to instructions in the
OPERATION section.
•
Pull the trigger on the gun and hold.
•
When the water supply is steady and constant,
disengage trigger and refasten the wand extension.
Engine Maintenance
Check Oil Level
•
Oil level should be checked prior to each use or at
least every 5 hours of operation. To check oil see
Engine Oil on page 8.
Changing Engine Oil
•
Change oil while engine is still warm. Preferably
drain oil from top of engine as illustrated below.
Drain oil with air cleaner side up. Oil can be
drained from engine bottom if necessary.
IMPORTANT: Before tipping engine or equipment to
drain oil, drain fuel from tank by running engine until
fuel tank is empty.
•
To drain oil from bottom of engine, remove drain
plug as illustrated below. Allow oil to drain and
replace drain plug. Remove dipstick and
refill with new oil of recommended grade. Start and
run engine at idle for 30 seconds.
OIL DRAIN
PLUG
•
Stop engine. Wait 30 seconds and re-check oil
level. If required, add oil to bring level to FULL
mark on dipstick.
Check Engine — Finger Guard/Muffler
•
Do not clean engine with a forceful spray of water
because water could contaminate fuel system.
With a brush or cloth, clean any debris from finger
guard after every use to prevent engine damage
caused by overheating.
•
Before running engine, clean muffler area to
remove all grass and combustible debris.
CLEAN
12
DRAIN HOLE
3/8" SQUARE
PIPE
CLEAN
CLEAN
Publicidad
Capítulos
Tabla de contenido
