Blade Assembly - Craftmade ELLINGTON TRD60PLN4 Guia De Instalacion

8. Blade Assembly.

Time Saver: Washers for blade screws can
be set on each blade screw prior to
installing blades.
Remove protective cover from end of
blade.
Locate 16 blade attachment screws
and washers in one of the hardware
packs. Hold blade arm up to blade,
aligning 4 holes in blade arm with
corresponding holes in blade. Then,
lower blade plate over holes in
blade arm, making sure to align all
4 holes, as shown in diagram at
right. Partially insert 4 blade
attachment screws (along with
washers). Securely tighten screws
with Phillips screwdriver only
after all 4 screws have been
inserted. Repeat procedure for
remaining blades.
Remove blade arm screws and lock
washers from fan motor and set aside.
To assemble decorative rod to blade, it
is important to follow the sequence
described here: Hold decorative rod so
that the long rod is aligned with the large
hole on one end of blade and so that the
slot in the foot at the other end of the
decorative rod is aligned with opposite end
of blade. [NOTE: Make sure to turn foot so
that the long rod comes STRAIGHT DOWN
from large hole instead of going across the
face of the blade.] Partially insert rod into
large hole and then fit slot in foot over tip
of blade, pushing against blade until holes
in foot align with holes in tip of blade.
Insert blade tip screws and tighten screws
securely.
Align blade arm holes with motor screw
holes and attach blade arm with lock
washers and blade arm screws. Before
securing screws permanently, repeat this
procedure with remaining blade arms.
Securely tighten all screws.
Note: Tighten blade arm screws and blade
tip screws twice a year.
protective cover
blade
attachment
screws and
washers
blade plate
blade arm
(long rod)
large
hole
blade arm screws
and lock washers
page 7
blade
blade tip
screws
blade
decorative rod
motor
housing
blade arm
(foot)
blade