Installing & Cleaning Foam Sleeve Filter; Installing And Cleaning Hepa Filter - Craftsman 125.12002 Manual Del Operador

Maintenance (continued)
Installing & Cleaning Foam Sleeve Filter
1 2
Installing Foam Sleeve Filter
1. Verify that the power cord is
disconnected from the outlet. (Fig.1)
2. Remove power head and place
in upside down position. Follow
instructions to remove cartridge fi lter.
3. Carefully slide foam sleeve fi lter down
over the fi lter cage making sure the
whole cage is covered. (Fig. 2 & 3)
4. Replace the power head on to the
collection tank.

Installing and Cleaning HEPA Filter

1 2
8
7
1. Verify that the power cord is
disconnected from the outlet. (Fig.1)
2. Unlock the fi lter door by lifting the lock
tab UP to the unlocked position and
pull the door out. (Fig. 2 & 3)
3. Remove the HEPA fi lter cartridge from
the vacuum. (Fig.4)
4
3
Cleaning Foam Sleeve Filter
1. With the removed power head in the
2. Use a mild soap and water solution
3. Allow fi lter to air dry before installing
3 4
4. Clean fi lter by brushing dirt off. For
5. Install the cleaned or new fi lter into
6. Insert the fi lter door tabs into the upper
11
5
upside down position, carefully remove
foam sleeve fi lter. (Fig. 4)
to wash foam sleeve fi lter and rinse
with clean water. (Fig. 5)
and using again.
5
optimal performance a new fi lter is
recommended. (Fig.5)
place. (Fig. 6)
slots and lock the fi lter door into place.
(Fig. 7 & 8)
6