Intended Use; Installing And Removing The Battery Pack - Craftsman CMCV002 Manual De Instrucciones

COMPONENTS (FIG. A)

Intended Use

The vacuum is designed to perform as a wet/dry unit
with no component changes required when changing
from wet to dry, or dry to wet pick up. This vacuum is for
household use only.
It is recommended that the tank be emptied of any dry
contents prior to being used for wet pick up to facilitate
tank cleaning.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
ASSEMBLY AND ADJUSTMENTS

WARNING:
serious personal injury, turn unit off and
disconnect it from power source before making
any adjustments or removing/installing
attachments or accessories. An accidental start-up
can cause injury.
Attaching Vacuum Hose (Fig. A, B)
The vacuum hose 8 will need to be attached to the
vacuum before using the appliance.
1. Place the vacuum on a flat, firm surface.
2. Unlatch tank latches and remove power head from
5
the tank. Remove the vacuum hose
3. Align the hose end 13 with the intake port
front of the appliance, ensuring the hose alignment lock
14 is aligned with the arrow
4. Insert the hose end into the intake port and twist
clockwise to lock in place.
5. Replace power head onto the tank and secure latches.
nOTE: The power head will only fit onto the tank when the
intake port on the front of the power head and the storage
area for the wide nozzle tool
Fig. B
14 15
13
To reduce the risk of
8 from the tank 4
6 on the
15 on the intake port.
12 on the tank are aligned.
OPERATION

WARNING:
serious personal injury, turn unit off and
disconnect it from power source before making
any adjustments or removing/installing
attachments or accessories. An accidental can
cause injury.

Installing and Removing the Battery Pack

(Fig. C)

CAUTION:
terminals are dry and clean before installing
battery pack.
To install the battery pack
the battery pack with the rails inside the tool's battery port
7 until the battery pack is firmly seated in the tool and
ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button 17 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. C
17
16
.
7
Using the Vacuum
On / Off Switch (Fig. A, D)
1. Attach the appropriate accessory to the vacuum hose
2. Insert battery pack.
3. To turn vacuum on, press the I/O (on/off) button
English
To reduce the risk of
Ensure battery port and
16 into the power head, align
1
8 .
.
7