StarMax STFFW40-F3F Manual De Usuario página 4

INSTALLATION
The fan must be installed into a wall stud or into a stable
wooden upright standing vertically from the floor.
CAUTION: To prevent the fan from falling down, be sure
to install it into a wall stud. Do not install it only into a
wall surface not backed with a stud.
Installing the mounting bracket
Fix the supplied mounting bracket firmly to the wall
using the three screws.
NOTE: The bracket should be positioned at least
14 inches from the ceiling and at least 12 inches
from adjoining wall.
IMPORTANT: Make sure the Mounting Bracket is
installed into a wall stud. Otherwise, use wall
anchors to provide proper support.
Installing the stand
Mount the stand on the bracket by inserting the
bracket catch into the slot on the stand.
Fix the stand to the bracket with the retaining nut.
NOTE: If the retaining nut does not pass through the
hole in the bracket, push the stand downwards until
it is fully mounted onto the bracket.
SPEED ADJUSTMENT
Adjust to the desired speed by pulling switch cord (A).
The control dial will click to a different position with
each pull of the cord.
Off---Off Low---Low Med---Medium High---High
OSCILLATION CONTROL
Pull switch cord B to start and stop fan oscillation.
To adjust vertical air direction, lightly push on the front
guard to tilt either up or down.
Wall stud
3
Speed Adjustment
Oscillation Control
0
3 1
2 2
1 3
SWING SPEED
0