cod. 54112 - mod. TB1200
Other people (children) or animals must not be within a 15 metre radius, because the
mowing head's rotation could project stones or similar objects around.
•
Store non-operating tools in a safe manner. Tools not in use must be kept in a safe,dry
place, so that they are not accessible, especially to children.
•
Disabling the tool. Always unplug the tool from the socket when it is not being used or
before attempting any repair job and/or any change of consumable tools.
•
Do not use the tool if you are tired and/or in poor health.
•
Expert, responsible people. Entrust the edge cutter only to people who know it and know
how to use it, always handing them the use instructions.
b) Warnings to ensure safe use
Important: The machines are intended exclusively for cutting ornamental grass
lawns, e.g. grassy edges. All other uses or complementary uses of the machine,
e.g. cutting of hedges or bushes, or large lawns, is not in keeping with the
purpose of the machines. The manufacturer shall not be in any way liable for
damage caused by the non-observance of these instructions. The risk shall be
exclusively at the user's responsibility.
Important: the cutting device continues rotating for a few seconds after the
motor is switched off.
Important: Switch on the motor only when your hands and feet are clear of the
cutting device.
•
Do not overload the tool. Do not force the tool to work under stress. You should therefore
avoid overloading with respect to the maximum available power. The tool will work
better and more safely within the limits of its rated power, whereas, otherwise, it could
be damaged and produce inaccurate work.
•
Dress adequately. Wear protective glasses or an eye shield, closed shoes with non-slip
soles, adhering work overalls, gloves and hearing protection.
•
Avoid incorrect use of the power cable. Do not lift the tool with the cable and do not
use the cable to unplug from the socket. Protect the cable against high temperatures,
oil, sharp edges, and other abrasive agents.
•
Avoid unsafe positions. When working, always stay in a safe, well-balanced position.
• Look after the tool. To work well and safely, you must always maintain the tool efficient
and clean, as follows:
1) Observe the instructions on maintenance and on changes of accessories and/or
consumable tools.
2) Regularly check the cable and, if it is damaged, have it replaced by a specialised
technician. Make sure that extension cables are suitable and undamaged and fully
unwound from the winding drum (with a minimum diameter of 1 mm
Always keep the grips dry and free of oil or grease.
•
Avoid unwanted starts by accidentally turning ON the switch while moving the machine.
Always make sure that the machine's switch is OFF before plugging the cable to the
electrical mains.
•
Always take maximum care, accurately observing the execution of the work, with good
awareness and without any distractions.
•
Check if the tool is efficient and without any faults or damage. Check all the following:
operation of moving parts, any failures, correct installation of all parts and all the other
conditions which could negatively affect efficient operation of the appliance. Never
).
2
- 19 -