Adjustments - Shindaiwa C3410 Manual De Propietario Y Operador

Assembly (continued)
Handle Bar C3410
Install the handlebar:
1. Use the 4 mm hex wrench to remove
the lower cap retaining screws from
the handlebar bracket. Remove the cap
from the bracket, and note the position
of the two " long spacers to be installed
between the bracket halves. See Figure 5.
. Position the handle on the outer tube
forward of Handle Positioning Label
as shown in Figure 5. Reassemble the
lower cap to the handlebar bracket in
the reverse order of disassembly.
3. Locate the handle in the best position for
operator comfort.
4. Firmly tighten both lower cap retaining
screws.
5. Secure the cable to the outer pipe with
the two bands provided in the tool kit.
See Figure 5.

Adjustments

Adjust Throttle Lever Free Play
The throttle lever free play should be
approximately 3/16-1/4 inch (4-6 mm). See
Figure 6. Make sure that the throttle lever
operates smoothly without binding.
If it becomes necessary to adjust the lever
free play, follow the procedures and
illustrations that follow.
3/16-1/4 inch (4-6 mm)
Throttle Free Play
Figure 6
Handlebar
bracket
Spacer
Lower Cap
Retaining Screws
Figure 5
Figure 7
1. Remove the air cleaner cover by loosen-
ing the two thumbscrews. See Figure 7.
. Loosen the lock nut on the cable
adjuster. See Figure 8.
Handle Positioning Label
POSITION HANDLE
FORWARD OF THIS LINE
Bands
27009B
Spacer
Lower Cap
3. Turn the cable adjuster in or out as
required to obtain proper free play
3/16-1/4 inch (4-6 mm). See Figure 8.
4. Tighten the locknut.
Cable
Adjuster
Lock Nut
Figure 8
5. Reinstall the air cleaner cover.
Handle Bar
C3410
7
7