Important - Renaware Aqua Nano UCU LX-200 CAL Uso Y Mantenimiento

b. Thread your existing cold water supply line that comes from the valve on the wall
into the side inlet of the 3-way-diverter
c. Thread the Braided Source Water Tube (supplied with the side faucet) onto the
bottom of the 3-way-diverter.
Braided water source tube
d. Remove the washer that is attached to the
smaller end of the Braided Source Water Tube
and place it in the small end of the tube, then
thread the small end of the tube onto the
Source Water Inlet of the Side Faucet
10
Line to your wall outlet
To the Side
Faucet
Braided water
source tube
6. Attaching installation assembly:
a. Install two new, high quality, AA batteries (not included) in the Filter Base. Insert
the Data Cable into the Data Cable Port on the underside of the base.
IMPORTANT: When the batteries are installed, the replacement lights
will fire a test sequence. If all lights do not light, you may have a broken
wire on installation.
data
cable
data
cable
port
b. Insert the Inlet Tube-to-Faucet Outlet
Connector (6) into the end of the Spout Outlet
Tube (the shorter tube without red tape).
11