Renaware Aqua Nano UCU LX-200 CAL Uso Y Mantenimiento página 8

Attach the inlet assembly: The Inlet Assembly (9) attaches to the top of the Pre-
8.
Filter Cartridge. It is inserted the same way the cartridges connect. Rotate the
Inlet Assembly approximately 1 /8 turn clockwise and make sure that there are no
kinks in the tubes.
9. Unit start up: Turn on the water supplies, and check for leaks above and below
the sink.
10. Flushing: To flush any residual carbon dust from the filter's manufacturing
process, and to expel air trapped in the filter, turn the new Side Faucet on. Allow
the water to run for 10 Minutes. Check for leaks.
11. Check installation: Turn the hot and cold taps of the existing faucet on. Both
should work the same way they did before. Check for leaks. Also turn the Side
Faucet on and off, both with the main faucet on, or off. The Side Faucet should
work independently from the main faucet.
14
12. Charge the system. To improve the flow rate and to reduce the "run on" of water
after the Side Faucet is turned off the system needs to be "charged". Charging
purges trapped air from the system.
Remove the Pre-Filter cartridge carefully to minimize the water that spills onto
the base unit.
Pour water into the top hole to fill
the Nano Ceram® cartridge.
Re-install the Pre-Filter cartridge and again pour in water into the top hole of the
Pre-Filter cartridge until it is full and reattach the inlet assembly.
Your Rena Ware Aqua  Nano water filter is now ready for you to enjoy!
15