Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions – LDA3B /LDA3BCP Commercial Recessed Adjustable LED
TILTING
1.
This fixture allows for up to 45-degree tilt. Please note
due to natural physical limitations of varying ceiling
thicknesses, trim aperture, and presence of additional
lens media, full 45-degree rotation may not be possible
and/or full light output from the fixture may be limited.
2.
It is recommended to remove the optic to perform this
operation due to the limited space.
3.
Tilt the mechanism by turning the tilting screw in the
clockwise direction (Figure 7c). Reference the angle dial
on the mechanism assembly for determining tilt angle.
4.
No additional steps are required for locking the tilt
position the mechanism automatically locks into the
desired position.
5.
Replace the optic.
6.
Please note:
a.
For wall wash trims, the optimal conditions
is 20-degrees tilt angle and 40-degree optic
(Figure 8).
Figure 8
TRIM INSTALLATION
1.
Remove the trim from its packaging.
2.
To clean, gently wipe with a soft, clean, dry lint-free
cloth to remove dust.
3.
In the event fingerprints are placed on the reflective
area, use a mild detergent solution on a soft, clean
cloth to remove them.
4.
Wipe with clean water and dry with a soft, clean, dry
lint-free cloth.
5.
The above cleaning method can be used anytime during
the life of the trim.
6.
Once the fixture is installed and the final position is
locked in, insert the trim into the collar by pinching the
torsion springs together (Figure 9) and insert them into
the torsion spring receivers.
7 .
If using a wall wash, the angle of the lens should
correspond with the direction and angle of the
mechanism head.
Torsion spring
receivers
Torsion springs
Figure 9
PORTFOLIO
IB520076ML
Torsion springs
Installation instructions
5
Publicidad
Tabla de contenido
