Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6.9
Electrical diagram
Do not invert the neutral with the phase in the
electrical supply line.
Check that the electrical supply of the burner
WARNING
corresponds to that shown on the identifica-
tion label and in this manual.
The section of the conductors must be at
least 1 mm
local standards and legislation).
Test the burner by checking the shut-down of the
burner by opening the thermostats and the lockout
by darkening the UV detector.
WARNING
Start-up, calibration and operation of the burner
~ 50Hz - 230V
P E
N
L
Main switch
F 1
T S
H T
R R
S B
White
T B
2
. (Unless requested otherwise by
Key (Fig. 16)
C: Capacitor
E: Electrodes
F: UV detector
F1: T4A Fuse
HT: Heat request thermostat
K: Pre-heater thermostat
MV: Fan motor
R: Pre-heater
RR: Remote reset
SB: Remote lockout signal (230V - 0.5A max.)
TB: Burner-earth
TS: Safety thermostat
V: Oil valve
X6: 6-pin plug
XP6: 6-pin socket
CONTROL BOX
Black
White
Blue
If the cover is still on, remove it and proceed with
the electric wiring following the wiring diagrams.
Use flexible cables in compliance with EN 60 335-
CAUTION
1 standards.
This control box has a post-purging function
Do not replace it with other versions!
WARNING
17
GB
20104050
Fig. 16
20094184
Publicidad
Capítulos
Tabla de contenido
