Operation
Figure 13
WARNING: This electric firebox
must be properly installed before it
is used.
The unit can be controlled by either
the manual controls which are located
on the upper right of the fireplace or
the remote (Figure 13 & 14).
The fireplace is supplied with an IR
multifunction remote control.
!
NOTE: To operate correctly, the
remote control must be pointed
towards the Floating Display
A.
Standby
Turns the unit On and Off.
→ Activated by pressing the Standby
button on the remote or the unit.
• The unit will turn on with the same
functions that it was set to when
it was turned Off and the intake
temperature will be indicated on
the Floating Display
!
NOTE: When any button is
pressed the intake temperature
will be displayed on the Floating
16
A
C D E
.
TM
.
TM
Figure 14
F
Floating
Display
TM
Display
for 5 seconds.
TM
B.
Flame Effects
Turns the flame effect On and Off.
→ Activated by pressing the
ton on the remote.
C.
Heat ON/OFF
Turns the heater On and Off.
→ Activated by pressing the
ton on the unit or the remote.
• Indicated by the
intake temperature being displayed
on the Floating Display
seconds before turning off.
!
NOTE: After the heater is
switched off, there is a 60 second
fan delay, where the fan will con-
tinue running before turning off.
!
NOTE: The unit can be oper-
ated in Heat Only Mode. When
the unit is only running with the
heater, the
ously be displayed on the Floating
A
B
D
F
icon and the
, for 5
TM
icon will continu-
www.empirecomfort.com
C
E
G
H
but-
but-