4-20Ma Loop; Default - Factory Settings - Macurco CD-6G Manual De Operación

Macurco CD-6G Operation Manual

4.4 4-20mA Loop

Clean Air – With the 4-20 mA function turned "On" and the current concentration of CO
mA reading equivalent to the current gas reading of the detector.
Fan Level – With the 4-20 mA function turned "On" and the current concentration of CO
Fan Relay Setting (Frs), the 4-20mA loop will output between 4 mA and 20 mA depending on the current concentration of CO
See figure 3 -1 4-20 mA Output diagram
3 1 T
Alarm Level – With the 4-20 mA function turned "On" and the current concentration of CO
the Alarm Relay Setting (Ars), the 4-20mA loop will output between 4 mA and 20 mA depending on the current concentration of
CO . See figure 3 -1 4-20 mA Output diagram
2
P P 3 1 T
Trouble – With the 4-20 mA function turned "On" and Trouble Fan Setting enabled. The 4-20mA loop will output less than 4 mA
or greater than 20 mA depending on the Trouble condition. See section
4.5 Default – Factory Settings
Setting:
Power Up Test
Display
Buzzer
Alarm Relay Setting
Alarm Relay Configuration
Fan Relay Setting
Fan Relay Delay
Fan Relay Minimum Runtime
Fan Relay Latching
Trouble Fan Setting
Awareness Alarm
4-20mA
CAL
REV – 1.0
or figure 3 -9 12-Series 4-20 mA Output diagram
3 1 T 3 1 T
or f igure 3-9 12-Series 4-20 mA Output diagram
3 1 T 3 1 T
Default:
Off
On
On
0.50% vol.
Normally Open (NO)
0.20% vol.
3 minutes
0 minutes
Off
Off
Off
bAS
diS
Table 4-1 – Default settings
[34-2900-0510-9 ]
ppm, the 4-20mA loop will output a
2
P P
ppm detected is at or greater than the
2
P P
3 1 T
ppm detected is at or greater than
2
P P
3 1 T
5 .1 On-Board Diagnostics .
3 1 T 3 1 T
.
2
P P
17
| P a g e